FDR0102-01
2-Channel Relay Module
The 2-Channel Relay Module from Fidar Electronics provides two relay outputs, driven remotely or from a sensor threshold. It connects to a FIDAQUIRE data logger over a daisy-chained CANopen bus.
Two independent relay outputs
Two independent relay outputs in one unit
Driven remotely or by a sensor threshold
Closes the loop from alarm to automatic action
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
A relay module closes the loop: a system that only reads can tell you something is wrong; a system with relays can do something about it. These two outputs are driven either remotely or automatically from a threshold set on any sensor in the system, and can switch a fan, a pump, a solenoid valve, a siren or anything else — bringing up an auxiliary fan the moment a server room passes its limit, with nobody driving to site at 3 a.m.
Key features
Two independent relay outputs
Two independent relay outputs in one unit
Driven remotely or by a sensor threshold
Closes the loop from alarm to automatic action
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
Connectivity
RJ45 CANopen output running at 125 kbit/s
Daisy-chain of up to 64 sensors on one FBC0232-01 card
Automatic input-break detection reported to the logger
Where it is used
Switching fans and auxiliary ventilation
Driving pumps, solenoid valves and process equipment
Triggering sirens and beacons on a critical condition
Remote switching without a site visit
Scheduled control of lighting and electrical loads
Remote power-cycling of hung equipment at unmanned sites
Installation
Never exceed the rated load in the specification table; use an interposing contactor for heavy loads.
| Dimensions | Height 3 cm, Depth 12 cm, Width 10.5 cm |
|---|---|
| Weight | 0.3 kg |
| Operating temperature | -10 to 45 °C |
| Storage temperature | -20 to 60 °C |
| Operating humidity | 0 to 60%, non-condensing |
| Warranty | 2 years |
| Mount | 2 Wall-mount holes |
| Number of Outputs | 2 relay outputs |
| Output Type | Dry-contact relay |
| Interface | RJ45 CANopen bus |
A relay module closes the loop: a system that only reads can tell you something is wrong; a system with relays can do something about it. These two outputs are driven either remotely or automatically from a threshold set on any sensor in the system, and can switch a fan, a pump, a solenoid valve, a siren or anything else — bringing up an auxiliary fan the moment a server room passes its limit, with nobody driving to site at 3 a.m. This model reports over a CANopen bus. Sensors daisy-chain onto a single shielded twisted pair that lands on an FBC0232-01 CANopen card inside a FIDAQUIRE data logger, so adding a station costs a tap on the existing cable instead of a new home run. Typical applications: • Switching fans and auxiliary ventilation • Driving pumps, solenoid valves and process equipment • Triggering sirens and beacons on a critical condition • Remote switching without a site visit • Scheduled control of lighting and electrical loads • Remote power-cycling of hung equipment at unmanned sites
FDR0102-01-Usermanual-EN
v1.0 · EN · 817 KB




