FAV0010-01
0–10 V Sensor
The 0–10 V Sensor from Fidar Electronics reads the 0–10 V analogue signal of industrial and building equipment and turns it into a logged, alarmable value. It connects to a FIDAQUIRE data logger over a daisy-chained CANopen bus.
0–10 V DC analogue input
Works with drives, dampers and voltage transmitters
Negligible loading on the source circuit
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
Power and data share one cable
The 0–10 V signal is the workhorse analogue interface in building and industrial equipment: variable-speed drives, dampers, motorised valves, lighting dimmers and many transmitters all speak it. This sensor reads that voltage and turns it into a logged, alarmable value, so the command sent and the feedback returned both land on one screen — and the gap between them, usually the first sign of a stuck damper or valve, does not stay hidden.
Key features
0–10 V DC analogue input
Works with drives, dampers and voltage transmitters
Negligible loading on the source circuit
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
Power and data share one cable
Connectivity
RJ45 CANopen output running at 125 kbit/s
Daisy-chain of up to 64 sensors on one FBC0232-01 card
Automatic input-break detection reported to the logger
Where it is used
Reading command and feedback on variable-frequency drives
Damper and valve position in HVAC systems
Connecting industrial transmitters with a voltage output
Lighting systems and 0–10 V dimmers
Logging laboratory sensors and measuring instruments
Building-automation equipment monitoring
Installation
Share a signal ground with the source device — a floating reference shows up directly as a reading error.
