FAC2000-04
3-Channel DC Current Sensor
The 3-Channel DC Current Sensor from Fidar Electronics measures direct current in a circuit across a 0 to 5 A range. It connects to a FIDAQUIRE data logger over a daisy-chained CANopen bus.
0–5 A DC measuring range
Three independent input channels in one unit
Suited to solar arrays and battery banks
Fast response to current drops and surges
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
A DC current sensor measures direct current in a circuit across a 0–5 A range. In solar arrays, battery banks and DC equipment, current is the clearest health signal there is: a drop in charge current, an abnormal draw or a leakage path all appear in the trend long before something fails. Logging that trend gives you both the early warning and the evidence for the post-mortem.
Key features
0–5 A DC measuring range
Three independent input channels in one unit
Suited to solar arrays and battery banks
Fast response to current drops and surges
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
Connectivity
RJ45 CANopen output running at 125 kbit/s
Daisy-chain of up to 64 sensors on one FBC0232-01 card
Automatic input-break detection reported to the logger
Where it is used
Photovoltaic string and array output monitoring
Battery bank charge and discharge current
DC circuits in server rooms, UPS and emergency power
Electric-vehicle charging stations
Telecom equipment and −48 V BTS sites
Consumption monitoring on sensitive electronic assemblies
Installation
The sensor goes in series with the load. De-energise the circuit before wiring and follow the polarity given in the manual.
