FTH1260-01
Type-K Thermocouple Sensor
The Type-K Thermocouple Sensor from Fidar Electronics measures high temperature with a Type-K thermocouple and automatic cold-junction compensation. It connects to a FIDAQUIRE data logger over a daisy-chained CANopen bus.
Type-K thermocouple input for high temperatures
Automatic cold-junction compensation
Fast thermal response for steep processes
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
Power and data share one cable
A Type-K thermocouple is a junction of two dissimilar metals that turns a temperature difference straight into a voltage. Its appeal is a very wide range, a fast response and tolerance of brutal conditions — which is why furnaces, burners and boilers use one where a PT100 would not survive. This sensor reads the thermocouple voltage and applies cold-junction compensation to recover the real process temperature.
Key features
Type-K thermocouple input for high temperatures
Automatic cold-junction compensation
Fast thermal response for steep processes
RJ45 output on a CANopen bus
Daisy-chains up to 64 sensors per card
Works with the FBC0232-01 card and FIDAQUIRE logger
Up to 500 m of bus at 125 kbit/s
Power and data share one cable
Connectivity
RJ45 CANopen output running at 125 kbit/s
Daisy-chain of up to 64 sensors on one FBC0232-01 card
Automatic input-break detection reported to the logger
Where it is used
Industrial furnaces and heat-treatment lines
Burners, steam boilers and combustion systems
Flue-gas and exhaust temperature measurement
Steel, foundry and glass industries
Extruder and mould temperature in plastics processing
Any point that needs a fast thermal response
Installation
Observe probe and compensating-cable polarity, and keep the tip out of direct flame radiation so the reading follows the process, not the fire.
| Dimensions | Height 3 cm, Depth 12 cm, Width 10.5 cm |
|---|---|
| Weight | 0.3 kg |
| Operating temperature | -10 to 45 °C |
| Storage temperature | -20 to 60 °C |
| Operating humidity | 0 to 60%, non-condensing |
| Warranty | 2 years |
| Mount | 2 Wall-mount holes |
| Input | K-Type Thermocouple |
| Output | RJ45 CANopen bus |
A Type-K thermocouple is a junction of two dissimilar metals that turns a temperature difference straight into a voltage. Its appeal is a very wide range, a fast response and tolerance of brutal conditions — which is why furnaces, burners and boilers use one where a PT100 would not survive. This sensor reads the thermocouple voltage and applies cold-junction compensation to recover the real process temperature. This model reports over a CANopen bus. Sensors daisy-chain onto a single shielded twisted pair that lands on an FBC0232-01 CANopen card inside a FIDAQUIRE data logger, so adding a station costs a tap on the existing cable instead of a new home run. Typical applications: • Industrial furnaces and heat-treatment lines • Burners, steam boilers and combustion systems • Flue-gas and exhaust temperature measurement • Steel, foundry and glass industries • Extruder and mould temperature in plastics processing • Any point that needs a fast thermal response
FTH1260-01-Usermanual-EN
v1.0 · EN · 816 KB




