FAV0010-11
Wireless 0–10 V Sensor
The Wireless 0–10 V Sensor from Fidar Electronics reads the 0–10 V analogue signal of industrial and building equipment and turns it into a logged, alarmable value. It links over a LoRa radio with no cabling at all.
0–10 V DC analogue input
Works with drives, dampers and voltage transmitters
Negligible loading on the source circuit
LoRa radio link up to 1 km line of sight
AES-128 encrypted payloads
Pairs with the FWL1600-01 LoRa card
No cabling; pairing takes seconds
Low-battery warning per node
The 0–10 V signal is the workhorse analogue interface in building and industrial equipment: variable-speed drives, dampers, motorised valves, lighting dimmers and many transmitters all speak it. This sensor reads that voltage and turns it into a logged, alarmable value, so the command sent and the feedback returned both land on one screen — and the gap between them, usually the first sign of a stuck damper or valve, does not stay hidden.
Key features
0–10 V DC analogue input
Works with drives, dampers and voltage transmitters
Negligible loading on the source circuit
LoRa radio link up to 1 km line of sight
AES-128 encrypted payloads
Pairs with the FWL1600-01 LoRa card
No cabling; pairing takes seconds
Low-battery warning per node
Connectivity
LoRa link up to 1 km with AES-128 encryption
Quick pairing with the FWL1600-01 receiver card
Sensor-fault and low-battery warnings before the cell dies
Where it is used
Reading command and feedback on variable-frequency drives
Damper and valve position in HVAC systems
Connecting industrial transmitters with a voltage output
Lighting systems and 0–10 V dimmers
Logging laboratory sensors and measuring instruments
Building-automation equipment monitoring
Installation
Share a signal ground with the source device — a floating reference shows up directly as a reading error.
